Getting The Best Swim Spa Cover

Swim Spas represent special obstacles when it pertains to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same factors a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, removing and replacing the Swim Spa Cover can be a lot harder.
Getting a brand-new swim spa is an exciting event in life. You’re eagerly anticipating the exercise you’ll receive from using it. Perhaps you’re a little relieved to have finally selected from the different models you took a look at. At any rate, you most likely weren’t thinking much about the Swim Spa Cover you would use.
Typically, the cover that gets home with your new purchase will be a 4 section stiff foam filled Swim Spa Cover that will split in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Integrated in obsolescence because as quickly as it is placed in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the Swim Spa Cover will still get heavy.
The reason is the steam from the water. The molecules of steam are very small as they increase from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the Swim Spa Cover
It occurs slowly and on a Swim Spa Cover which is made from specific sections, at varying speeds. So eventually you’ll discover one or two of the sections are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance since you still have to raise that heavy Swim Spa Cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com created a different style for their Lightweight Swim Spa Covers
Instead of using a number of foam panels that will eventually end up in some garbage dump, they developed Lightweight Swim Spa Covers that uses air chambers that do not suck up moisture.
In fact SpaCap.com Lightweight Swim Spa Covers are easy to use, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these Lightweight Swim Spa Covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to buy today, bookmark this site so you can discover it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *