Getting The Best Swim Spa Cover

Swim Spas represent distinct challenges when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the Swim Spa Cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing event in life. You’re looking forward to the exercise you’ll get from using it. Maybe you’re a little relieved to have finally selected from the various designs you took a look at. At any rate, you most likely weren’t believing much about the Swim Spa Cover you would use.
Typically, the cover that comes home with your new purchase will be a 4 section rigid foam filled Swim Spa Cover that will split in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence due to the fact that as quickly as it is placed in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the Swim Spa Cover will still get heavy.
The factor is the steam from the water. The particles of steam are very little as they rise from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the Swim Spa Cover
It occurs slowly and on a Swim Spa Cover which is made of specific sections, at differing speeds. So eventually you’ll see one or two of the areas are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much aid because you still need to lift that heavy Swim Spa Cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different style for their Lightweight Swim Spa Covers
Instead of using a number of foam panels that will eventually end up in some land fill, they designed Lightweight Swim Spa Covers that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Lightweight Swim Spa Covers are easy to use, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these Lightweight Swim Spa Covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this website so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *